This was on the interior side of a 6 panel metal door we were trying to make look like oak, but could not get the effect we wanted. The glaze was mixed with polyurethane.  Is there a way to remove just the glaze or will we have to start over

New oak cabinets, want to keep them light. So what type of stain or vanish or what would I use?

I am having new doors made. I’m in the processing of cleaning up the bases. I had sanded an area where it was water stained. I tried putting stain on and it did not take. Any ideas?

I have a bathroom vanity I want to paint, but not sure what to do to prep it, or what type of paint to use? The vanity appears to be particle board covered with a laminate finish to make it smooth. Thanks for replies in advance.

I am refinishing oak cabinet doors. I already repaired the crappy sand job the contractors ahead of me left. I conditioned, applied 2 coats colored gel stain and two coats clear. Out of 22 doors, 3 didn’t look right. So I sanded them all back down and started over. I

I want to restain the vanity in my bathroom the same color or maybe slightly darker. Will I need a primer before restaining the wood finish?

My bathroom vanity cabinet is honey oak, feeling very dated. Can I stain them a darker colour to try to update them without having to replace them?

My particle board cabinets have some kind of stain and I want to resand them and restain? Will sanding with 220 grit and 320 be OK? What prep. should I use? I sanded on one area and the stain comes off very easily but want to know if I can

Can I use acetone (fingernail polish remover) to strip my kitchen cabinets without affecting the wood in any way. I have done a spot and it removes the pickled finish perfectly.